Theatre Solution Jury Base Chair Aeron - Manual (Page 2)

Aeron Jury Base Chair Specifications
Page 2 of 3
product quoted does not comply with the specifications.
C. Failure to comply with the warranty described in Part 4 of these specifications will be cause for
disqualification.
2.2 MATERIALS
A. Seating material shall be Herman Miller Pellicle
®
with the color and pattern to be selected from the
standard offering.
2.3 FABRICATION, GENERAL
A. Fabricate the seating for maximum comfort using materials that are carefully selected to be free from
defects, objectionable projections, or irregularities. Smooth round corners and edges to present the least
possible snagging and pinching hazards.
2.4 MOUNTING
A. The floor base shall be cast aluminum with a durable powder coated finish. The base shall include four
countersunk holes equally spaced around the perimeter of the base for mounting to the floor with 1/4” flat
head screws, providing a flush, unobtrusive appearance.
2.5 CHAIRS
A. Chair shall be Herman Miller model Aeron
®
.
B. Chairs shall include a separate seat and back and shall consist of a durable, breathable Pellicle material
stretched within a carrier ring and fitted into an outer frame. The Pellicle material shall be a woven blend of
spandex and colored polyester yarn with Hytrel elastomeric polyester. The carrier ring shall be a glass-
filled elastomeric copolymer molded around the perimeter of the Pellicle material. The outer frame shall be
injection-molded, glass reinforced thermoplastic polyester. The ring and frame shall be secured together
with screws.
C. Chairs shall include the Kinemat
®
tilt mechanism.
D. The chair shall be equipped with a swivel and return cylinder.
PART 3 – OPTIONS
3.1 ARMS
A. Each fixed arm shall have an armpad support and a yoke, both of die cast aluminum with either a polished
or wrinkle coat powder-coated epoxy finish. A support shall attach to the arm yoke with screws, and the
yokes shall attach with screws to slots in the swing arms, at the left and right of the chair back.
PART 4 – WARRANTY
4.1 The Jury Base seating manufacturer must provide a Warranty to the original purchaser of the seating as follows:
A. The manufacturer shall warrant the product for five (5) years from the date of shipment. This warranty
applies to the original purchaser and is non-transferable. The manufacturer will provide parts and labor to
replace defective parts for the first two years after installation. Thereafter, TSI will provide replacement
parts for the remaining 3 years.
B. This warranty shall not cover damage from abuse, misuse, neglect, or act of God. Damage caused by
modifications to the product by anyone other than an authorized seating manufacturer technician will void
this warranty. This warranty does not apply to fabrics or products not installed by authorized seating
manufacturer technicians.
PART 5 - EXECUTION
5.1 EXAMINATION
A. Examine site conditions, with installer present, for compliance with requirements for construction tolerances
as they affect anchors and fasteners, and location of junction boxes.
B. Do not proceed until unsatisfactory conditions have been corrected.
5.2 GENERAL