Theatre Solution Jury Base Chair Forum - Manual (Page 2)

Forum Jury Base Chair Specifications
Page 2 of 3
product quoted does not comply with the specifications.
C. Failure to comply with the warranty described in Part 4 of these specifications will be cause for
disqualification.
2.2 MATERIALS
A. Padding material shall be flame retardant polyurethane foam which conforms to the standards of the
California Bureau of Home Furnishings 117-75.
B. Seating fabric shall be _______________________________________________ with the color to be
selected from the standard choice of colors. All upholstery shall be first quality without creases, stretch
lines, or wrinkles.
2.3 FABRICATION, GENERAL
A. Fabricate the seating for maximum comfort using materials that are carefully selected to be free from
defects, objectionable projections, or irregularities. Smooth round corners and edges to present the least
possible snagging and pinching hazards.
2.4 MOUNTING
A. The floor base shall be cast aluminum with a durable powder coated finish. The base shall include four
countersunk holes equally spaced around the perimeter of the base for mounting to the floor with 1/4” flat
head screws, providing a flush, unobtrusive appearance.
2.5 CHAIRS
A. Chair shall be TSI model Forum.
B. The inner shell shall be an electronically glued plywood construction of varying thicknesses. The minimum
thickness shall be 1/2” - 7plys with a maximum thickness of 11/16” - 11 plys. The shell shall be contoured
to an ergonomically correct configuration.
C. Padding material shall be fire retardant polyurethane foam which conforms to the standard of the California
Bureau of Home Furnishings Bulletin 117-75. Foam padding shall not be less than 2” thick at any location
on the seat surfaces and shall not be less than 1-1/2” on any location on the back surface. Foam shall be
2.5 lb. density and 45 lb. IFD rating.
D. Chair shall include a non-tilt mechanism.
E. The chair shall be equipped with a swivel and return cylinder.
PART 3 – OPTIONS
3.1 ARMS
A. Arms shall be constructed of a steel bar with a self-skinned urethane overmolding. Arms shall be attached
to the chair with an 11 gauge cold-rolled steel bracket. The arms shall be attached to the bracket with (2)
M6 x 20mm bolts, and the bracket shall be attached to the chair frame with (3) 1/4-20 x 1-1/4 Grade 5
bolts.
3.2 TILT MECHANISM
A. Chair shall include a tilt mechanism with a tilt tension adjustment.
3.3 COMPLIANCE WITH CALIFORNIA TECHNICAL BULLETIN 133
PART 4 – WARRANTY
4.1 The Jury Base seating manufacturer must provide a Warranty to the original purchaser of the seating as follows:
A. The manufacturer shall warrant the product for five (5) years from the date of shipment. This warranty
applies to the original purchaser and is non-transferable. The manufacturer will provide parts and labor to
replace defective parts for the first two years after installation. Thereafter, TSI will provide replacement
parts for the remaining 3 years.
B. This warranty shall not cover damage from abuse, misuse, neglect, or act of God. Damage caused by
modifications to the product by anyone other than an authorized seating manufacturer technician will void
this warranty. This warranty does not apply to fabrics or products not installed by authorized seating