Theatre Solution Jury Base Chair Teatro - Manual (Page 3)

Teatro Jury Base Chair Specifications
Page 3 of 4
A. Back Construction: Solid back construction comprised of a curved plywood veneer outer panel fastened
solidly and without voids to an inner structural plywood panel. The outer panel shall be 15mm thick, faced
one side with Grade A veneer centered across the width of the panel and 1/8” thick hardwood matching the
species of the veneer along the top and vertical edges. The inner panel shall be 3/8” thick. Both shall be
electronically glued hardwood plywood and shall be fastened together with bayonet hanging brackets at the
top and two #8 x 3/4” trim head screws at the bottom, resulting in a rigid connection with no visible
fasteners on the outer wood panel. The veneer face and edges of the outer panel shall be stained to
match the architect’s sample. The padding material shall be 1-3/4” thick polyurethane foam, 2-3/4” thick in
the lumbar region, shall be glued to the inner panel, and shall conform to the California Bureau of Home
Furnishings Technical Bulletin 117. The back assembly shall be attached to the frame assembly using (2)
1/4-20 x 3/4” flat head machine screws and (2) 3/8-16 x 1-1/4” flat head machine screws.
3.3 INSET UPHOLSTERY, BACK
A. Back upholstery shall be inset to expose the veneer face on the inside of the outer back panel. The veneer
on the inside face on the back panel shall match the veneer species on the outside face and be stained to
match.
3.4 END PANEL
A. Provide manufacturer’s standard end panel for both sides of each chair. The configuration of the panel
shall follow the angle of the frame and back at the rear, and shall be vertical at the front end. The panel
shall be constructed of 3/4” thick plywood with veneer on both sides and 1/8” thick hardwood on the vertical
edges. The end panel shall be stained to match the outer wood seat, back, and armrests.
3.5 TILT MECHANISM
A. Chair shall include a tilt mechanism with a tilt tension adjustment.
3.6 COMPLIANCE WITH CALIFORNIA TECHNICAL BULLETIN 133
PART 4 – WARRANTY
4.1 The Jury Base seating manufacturer must provide a Warranty to the original purchaser of the seating as follows:
A. The manufacturer shall warrant the product for five (5) years from the date of shipment. This warranty
applies to the original purchaser and is non-transferable. The manufacturer will provide parts and labor to
replace defective parts for the first two years after installation. Thereafter, TSI will provide replacement
parts for the remaining 3 years.
B. This warranty shall not cover damage from abuse, misuse, neglect, or act of God. Damage caused by
modifications to the product by anyone other than an authorized seating manufacturer technician will void
this warranty. This warranty does not apply to fabrics or products not installed by authorized seating
manufacturer technicians.
PART 5 - EXECUTION
5.1 EXAMINATION
A. Examine site conditions, with installer present, for compliance with requirements for construction tolerances
as they affect anchors and fasteners, and location of junction boxes.
B. Do not proceed until unsatisfactory conditions have been corrected.
5.2 GENERAL
A. Comply with seating manufacturer’s printed installation instructions applicable to products.
B. Locate seating in locations indicated on approved shop drawings, with required clearances.
C. Install standards in locations conforming to seating layout, with each chair base attached to substrate by no
less than four anchoring devices of size and type required to insure that chairs are stable under conditions
of actual use.
D. Install chairs using manufacturer’s recommended hardware and fasteners. Insure that chairs in curved
rows are installed on proper radius and are oriented toward the center point of the radius. Verify that
moving components operate smoothly and quietly.
5.3 ADJUSTING
A. Adjust as required to assure that the seats in each row are aligned when in the unoccupied position.