SCANTECH ID (Champtek company) V-1040BT - Manual (Page 64)

56
4.22 Telepen Parameters
4.22.1 Type of Code
Telepen Numeric
4.22.2 Check Digit Transmission
Do Not Calculate Check Digit
Calculate Check Digit and Transmit
Transmit>
4.22.3 Setup Code Length
To set the fixed length: (2 sets available)
1. Scan the “Begin” programming code of the desired
set
2. Go to the Decimal Value Table in Appendix A. Scan
programming codes that represent the length to be
read.
3. Scan the “Complete” programming code of the desired
set.
Repeat the steps 1 – 3 to set additional length.