SCANTECH ID (Champtek company) IG300BT - Manual (Page 9)

9
ATTENTION:
It is important to know that the scanner will only
communicate with the cradle with the unique Bluetooth
MAC address. Other scanner can not pair with that
cradle until the original connection is broken. If the
cradle pairs with another scanner, the cradle will
disconnect with the first scanner and then re-connect
with another scanner.
3.3 Set up Slave Mode Communication
Please follow the below steps to set up the
communication between the scanner and Bluetooth
application device.
1) The scanner must scan “Scanner Slave Mode”
barcode, to set the scanner in Slave mode.
2) Enter the pin code (default 000000) to setup
comport when control the Bluetooth device to
search the scanner.
3) When the scanner is successful connected,
scanner will sound 1 long beep.
4) If successful, Blue LED of scanner will slow flash.
5) If the connections failed the scanner indicates with
3 shot beeps.
3.4 Scanner Slave/Master Mode
Scanner Slave Mode