SCANTECH ID (Champtek company) IG300BT - Manual (Page 8)

8
3. Set up Bluetooth
Communication
Before the operation, Bluetooth Communication must
be set up between the scanner and cradle.
3.1 Pairing
Each scanner has to be paired to a cradle by scanning
the unique Bluetooth MAC address code located on
the bottom of cradle. The pairing between scanner and
cradle is one to one that is one scanner can be paired
to a cradle only.
3.2 Set up Master Mode Communication
Please follow the steps to set up the communication
between the scanner and cradle.
1) The scanner must scan “Scanner Master Mode”
barcode, to set the scanner in Master mode.
2) Scan the Bluetooth MAC address code located on
the bottom of the cradle.
3) When the Bluetooth MAC address code was
successfully scanned, scanner will sound 2 short
beeps with blue and red LED flash once.
4) Wait approximately five seconds, for completing
the connection process with a long beep sound.
5) If successful, Blue LED of scanner will slow flash
and the cradle will be continued on.
6) If the connections failed the scanner indicates with
3 shot beeps and the cradle with blinking blue LED.