SCANTECH ID (Champtek company) IG300BT - Manual (Page 5)

5
2. Installation
2.1 Unpacking
1) Take device and its accessories out of the box.
2) Remove the packing material.
3) Check the standard shipment packing list to make
sure you have received all of the items ordered.

Wireless 2D Imager Scanner
 Bluetooth Cradle or Charger (optional)
 Power Adaptor (if applied)
 Communication Cable
 Skip resistant pad
 Iron panel of cradle and screw
 Quick Start Guide
4) Visually inspect the device and accessories for any
evidence of physical damage.
5) If anything is missing or appears to be damaged,
immediately contact your dealer.
2.2 Mounting
Once you have unpacked all components, you can
start installing the device as below steps:
IG300BT Scanner
1) The Scanner must be charged for a minimum of
8 hours before the scanner can be placed in full
operation for the first time.
2) The cradle will indicate in red light when the
scanner is being charged.
3) Once the battery is full, green LED of scanner
will be ON. And green light will be OFF when
the scanner leaving from cradle. The battery
will over charged when battery full charged
again, red and green LED will flashing.
4) If the battery power capacity is too low, the
scanner will indicate with red LED and beeper
warning.