Billet Specialties 12120 Power Steering Bracket - Manual

For use with:
• Chevy small block
• Short water pump
• GM type 2 remote pump (86-93 S-10 4-cyl.)
1. Use Loctite® removable threadlocker 242 (blue) on all fasteners.
2. Bolt power steering bracket [B] to threaded bosses on driver side
of block using 3/8-16 x 1-1/4” SHCS [D] and 3/8” flat washers [E]
as shown in the illustration. Tighten.
3. Press pulley onto GM remote type 3 pump using proper
installation tool. Pump application is 86-93 S-10 4-cylinder.
Aftermarket pumps are available with -6 and -10 AN fittings
installed.
4. *Install pump onto bracket [B] using 5/16-24 x 3” SHCS [F] and
5/16” lock washers [G]. Use t-nut slide adjuster [C] on adjustment
side of bracket. Do not fully tighten.
5. Install power steering belt on the outside groove of the 3-groove
crank pulley.
6. Apply tension on the power steering belt and tighten bolts [F]
5/16-24 x 3” SHCS.
*Hoses can be installed on pump prior to pump being installed for ease of
assembly.
-6 AN hose: From power steering pump to inlet side of steering box or rack.
-10 AN hose: From power steering pump to remote reservoir.
#12120 Power Steering Bracket
Mounting Instructions
BILL OF MATERIALS
ITEM QTY. DESCRIPTION SIZE
A 1 Power Steering Pulley
B 1 Power Steering Bracket
C 1 5/16”-24 Slide Adjuster
D 2 3/8”-16 Socket Head Cap Screw 1-1/4”
E 2 Flat Washers 3/8”
F 2 5/16”-24 Socket Head Cap Screw 3”
G 2 Lock Washers 5/16”
Billet Specialties • 500 Shawmut Avenue • La Grange, Illinois 60526• Tech 708-588-0505 • Fax 708-588-7181
A
D
E
D
E B
F
G
C
F
G
Pump Side Of Pulley