Billet Specialties Full Size Chevy Replacement Gas Pedal #199240 - Manual

Billet Specialties, Inc. 500 Shawmut Avenue La Grange, Illinois 60526 PH 800.245.5382 Fax 708.588.7181 www.billetspecialties.com
AUG 08
Full Size Chevy
Replacement Gas Pedal #199240/ #199245
Tools Needed:
• 1/16” Allen Wrench
• 5/32” Allen Wrench
• 1/2” Deep Well Socket
• Loc-tite® Thread Locker Applications:
• ‘58 - ‘64 Bel Air, Biscayne, Impala
• ‘64 - ‘67 Nova, Chevelle, El Camino
1. Remove factory gas pedal from floor.
2. Remove ball studs from floor.
Spray penetrating oil on threads and let soak.
Use a 1/2” deep well socket to engage hex at
bottom of ball stud to remove.
3. Vacuum carpet/floor area around gas pedal
location to remove debris and ensure a clean
mounting area.
4. Apply Loc-Tite® thread locker on the threads
of the two 1/4-20 x 1” button head cap screws.
5. Install lower bracket and pedal return spring as
shown to the vehicle floor with the two 1/4-20 x
1” button head cap screws. Tighten firmly.
6. Place replacement pedal on floor and attach
by inserting the hinge pin as shown through the
holes in the upper and lower brackets.
7. Apply Loc-Tite® thread locker on the threads
of the 6-32 x 1/8” set screw and install into the
lower bracket; locking hinge pin into position.
Tighten firmly.
8. Check pedal action, make sure pedal moves
freely and does not bind.
1. Remove screws that attach plate to floor.
2. Remove ball studs from plate by drilling out the
backside of the ball stud attachment.
3. Bolt assembled pedal to plate using 1/4-20 x 1/2”
button head cap screws and lock nuts (not included).
4. Reinstall plate with pedal to floor.
Install as shown below for correct
alignment and easier installation.
The upper bracket is pre-installed
on the backside of the pedal
6-32 x 1/8” Set Screw
Into lower bracket to lock pin
For proper installation note
direction of pedal return spring.
1/4-20 x 1” B.H.C.S.
Thru lower bracket to floor
Some vehicles may have a gas pedal
mounting plate like the one shown below