SENA Parani100 - Manual (Page 36)

- 36 - 36
3. Firmware Download
4. Serial Port (RS232)
5. Reset
6. Reboot
7. Change password
8. System Log
q. Quit
>> 4
--- Serial Port Configuration ---
AT command interface: Disabled
115200 bps 8-N-1 hardware
1. Baudrate
2. Character Size
3. Parity
4. Stopbit
5. Flow Control
6. AT command
q. Quit
>>
- Logout the console (q.Quit)
- To apply changes to the configuration, turn off the Parani100.
- Users will need to move the Switch on the left side of Parani100 to right side
position for Data communication.
- Turn on the Parani100, and then Parani100 will start operating in RS232 mode.
Please note that if you need to make use of data communication via RS232 port,
you will not need to configure Network settings.