SENA Parani100 - Manual (Page 35)

- 35 - 35
i) Set the serial configuration of Parani100
As RS232 port has been configured to be used as a Configuration port, which allows
users to access the configuration utility of the Parani100. When the Parani100 is set to
RS232 Mode, users will need to change the Switch on the left side of Parani100 to the
Data position to allow for proper data communication to occur.
- Login the console of Parani100 (Default: 115200-N-8-1-Flowcontrol None)
- Select menu #4. Serial Port (RS232)
- Set the serial parameters like below.
Parani100 Configuration Console ----
-- Press Enter ---
login: admin
Password: *****
Parani100 ver 210.76 -----------------------------
Copyright (C) 2005 Sena Technologies
-----------------------------------------------
SN : 050510003
Bluetooth
dev0 - 00:0B:53:20:04:51
Network [dhcp]
IPaddr 192.168.222.16 HWaddr 00:01:95:00:00:32
Netmask 255.255.0.0 Gateway 192.168.1.1
DNS1 168.126.63.1 DNS2 168.126.63.2
LAP profile : [disabled]
--- Main Menu ---
1. Network Settings
2. LAP