Ocean Optics ADC5000 - Manual (Page 2)

Install the ADC500
1. Turn off the computer and remove the computer cover.
2. Ground yourself to the computer chassis or power supply and remove the A/D card from its static-shielded bag.
3. If necessary, change the position of the switches on the A/D board. Position the switches to match the available
settings you found in the previous section -- numbers not being used by other hardware devices. See pages 5
and 6 for switch setting positions.
4. Find an open ISA-bus slot and remove the slot protector.
5. Insert the A/D card into an available expansion slot on the motherboard by gently rocking the card into the slot.
Make sure the card is fully seated in the motherboard before screwing the tab on the A/D card to the computer.
Do not bend the card or move it from side to side once it is seated in the slot.
6. Attach the D37 end of the cable to the card and the D25 end to the spectrometer. Reinstall the cover.
Install OOIBase32
Before installing OOIBase32, make sure that no other applications are running.
1.
Execute Setup.exe.
2. At the “Welcome” dialog box, click Next>.
3. At the “Destination Location” dialog box, accept the default or choose Browse to pick a directory. Click Next>.
4. At the “Backup Replaced Files” dialog box, select either Yes or No. We recommend selecting Yes. If you select
Yes, accept the default or choose Browse to pick a destination directory. Click Next>.
5. Select a Program Manager Group. Click Next>. At the “Start Installation” dialog box, click Next>.
6. Follow all prompts regarding the Spectrometer Configuration diskette that came with your system. For more on
the Spectrometer Configuration diskette, see the
Note below. (If you downloaded OOIBase32 from the Ocean
Optics web site, you will not have this diskette. Select No when first asked about the diskette.)
7. At the “Installation Complete” dialog box, choose Finish>.
8. Restart your computer when the installation is complete.
Note:
In your spectrometer shipment box, you received a Wavelength Calibration Data Sheet wrapped around a
floppy diskette. The Wavelength Calibration Data Sheet and the spectrometer configuration file on the floppy
diskette contain the same information, which is unique to your spectrometer. When you install OOIBase32, you
are prompted to insert this diskette into your computer so that this data is installed with the software. However,
if the diskette is ever lost, or if you downloaded OOIBase32 from the our web site and did not receive a
diskette, you can use the data on the Wavelength Calibration Data Sheet to enter into OOIBase32 fields.
Run OOIBase32
After you restart your computer, navigate to the OOIBase32 icon and select it. The first time you run OOIBase32
after installation, you must follow several prompts before you can begin taking measurements.
Operator and Serial Number Dialog Box
First, a prompt to enter a user name and serial number appears. Certain data files will include this information in the
header. (If, at a later date, you wish to change the operator name and serial number, select Edit | Settings from the
menu and then choose the Registration tab.) Click OK.
Default Spectrometer Configuration File
Next, the following message appears:
This appears to be the first time OOIBase32 has been executed. Please select a default spectrometer configuration
file from the following screen. This spectrometer configuration file will be used each time OOIBase32 is started.
Operating Instructions: ADC500 (for Windows 95/98 Users)
- 2 -