Ocean Optics BluLoop Multi-LED - Manual (Page 10)

1: Setup
2 000-blulo-110-02-201204
2. Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present.
3. Switch on the unit and check if the light source including the fan is working.
WARNINGS
Do not stare into the source of the light beam.
Handle the product with care. Do not let any objects or liquids enter into the device
or in the optical path of the light source.
4. Use this instrument in a clean laboratory environment.
Package Contents
Your BluLoop light source package should contain the following:
 BluLoop light source
 Power Supply 6 Vdc upto 3000 mA with different plug adaptors
 Hexagonal socket screw key SW 1.3
 This manual
Varying the Optical Output Intensity
You can vary the intensity of the optical output by sliding the SMA holder parallel to the light beam.
► Procedure
To change the light intensity,
1. Loosen the stud screw with the hexagonal socket screw key SW 1.3 that you received with
your light source.