Ocean Optics MPM-2000 - Manual (Page 19)

3: Operating Instructions
000-10000-120-1209 11
Program Mode
Program Mode allows you to create or change sequence programs used by the MPM-2000. The Program
Mode interface contains the following items:
Item Description
Step Column Identifies the individual step number in the sequence program
Channel Identifies the channel that the MPM-2000 will switch to in this step
Time to wait Identifies the delay time before the MPM-2000 proceeds to the next step
Time unit Defines the unit of time for the Time to wait column
Continuous
When checked, instructs the software to run the sequence program a
specified number of times (specified in the no of runs box)
No of runs
Specifies the number of times the software will execute the sequence program
(a value of –1 instructs the software to run the program until manually
stopped)