Ocean Optics INTSMA Slit - Manual (Page 3)

INTSMA Slit Installation Instructions
013-INTSMA-000-01-201209 3
Installing the Slit
Follow these instructions to install a new slit in your spectrometer. These instructions use the Jaz as an
example, but the slit installation is the same for the Torus and QE65 Pro spectrometers.
►
Procedure
1. Locate the Spectrometer module in your Jaz stack (should be located at the bottom of the
stack). (This step is not necessary for Torus and QE65 Pro spectrometers.)
2. Locate the SMA connector. Remove the fiber if one is attached.
3. Using the hex driver, remove 2 the screws attaching the slit to the spectrometer. Then, remove
the slit from the module by pulling it straight out.
4. Place the new INTSMA slit connector into the spectrometer; the key of the connector goes on
the right.