Ocean Optics LS-475 - Manual (Page 10)

1: Setup
2 000-10000-100-02-1209
Unpacking the LS-475
► Procedure
1. Unpack your lamp assembly carefully. Although the blue LED lamp is rigidly mounted, dropping
this instrument can cause permanent damage.
2. Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present. Contact your dealer for repair or replacement information, if
necessary.
3. Use this instrument in a clean laboratory environment (see Operating Environment ).
Contents
Your LS-475 package should contain the following:

LS-475 Blue LED Pulsed Light Source

One IC-DB15-2 interface cable for shutter operation
Additionally, you will need an approved power supply for the LS-475, such as the Mikropack PS-
12V/1.25A power supply.
General Configuration
► Procedure
To set up your LS-475,
1. Plug the power supply into an outlet and into the back of the LS-475
2. Screw an optical fiber onto the SMA connector on the front of the light source.