PolyPlanar MRD-60 - Manual (Page 9)

9
Repair / Returns
If your Poly Planar radio is not functioning correctly contact our Service
Department: Ph. 410-761-4000 or Fax: 410-761-6274
All returns must have a Return Authorization number
No returns will be accepted without a Return Authorization Number
INTRO, SCAN
CD: Press the INTRO button (6) to enter into Scan Mode, SCN will
appear in the left side of the display. In this mode the first 10 seconds
of each track will play.
MP3 Disc: If the disc is an MP3 the first 10 seconds of each track will
play and then advance to the next directory. Press the INTRO button
for 3 seconds and DCN will appear in the display. In this mode the first
10 seconds of the first track in each Directory will play.
CD Changer: If an MCD6 changer is installed pressing the INTRO
button will show SCN in the left side of the display. The main display
will show which CD is playing. In this mode the first 10 seconds of each
track of each CD in the magazine will play. Pressing INTRO for 3 sec-
onds will change the display to CDC and play the first ten seconds of
the first track on each disc.
RANDOM, REPEAT
Press RANDOM button to play the tracks of the current CD or MP3 disc
in random order. RDM will appear on the left side of the display.
Press the REPEAT button and the current song will replay. RPT will
appear on the left side of the display.
TROUBLESHOOTING
Front Panel buttons: It is possible to press the elastomeric buttons in
a way that will allow them to stick under the panel face. This will stop
further function. Simply push again to re-center.
Reset Button: A system reset button is located inside the front panel.
Use a paperclip or thin rod to press the rest button if required. This will
restore factory defaults.
Fogged CD or lens: This may occur in certain conditions. Wipe CD
with soft dry cloth. The optical components will return to normal when
the radio warms up.
Unit will not turn on - Check Power Connections and voltage to unit
- Check Fuses (Red 10A, Yellow 1A)
- Check front panel for stuck buttons.
- Press reset button (see page 9)
CD will not play
Volume up stops but
indication continues
to ―31‖
- Check disk for Damage
- Try another CD/MP3 disc
- Check for stuck buttons
- Press reset button
- Check available voltage
- This indicates insufficient wire size on power
connection
Error Codes Error Codes are indicated on the Display
E-03 - Read Error, Possible bad Disc , Retry with new
disc
-Try reset button
E– 07 - General Error code. This normally indicates a
CD Deck failure . Contact Service Center
9