PolyPlanar MRD-60 - Manual (Page 5)

5
Receiver Side
Power & Speaker Harness Connections
Important!
Disconnect power before installation.
If you are not familiar with this type of installation
seek professional assistance
Use the wired plug end
(Pig tail) provided to
make power and speaker
connections according to
the diagram on the right.
Using this connector will make it easy
to disconnect the radio for adding ad-
ditional features or service. Removing
the factory plug end will void war-
ranty
The 12v Positive and Negative con-
nection should be min. 16 or 14 AWG
depending on length to the battery.
Be sure to observe the correct polarity
on the speaker connections
To Radio
12v out (low current)
Relay trigger
5