Getting started – PolyPlanar MRD-60 User Manual

Page 7

Getting Started….

Power On / Off

Push (1)to power on unit , Push again to turn unit off.

Adjusting the Volume

Rotate Volume knob (4) to increase or decrease volume level. Current
setting is displayed for a few seconds.

Mute

Push (2) to mute sound, push again to resume

Program Selection

Press the Source button (3) to cycle through the available program
sources: Tuner>CD>CD Changer> AU-1> AU-2> Tuner

If a source is not active or disconnected that source will not appear.

If the CD Changer is attached but has no magazine inserted it will display
“EJECT”

Adjusting the Audio levels

Pressing

AUDIO

button (12) will indicate

BAS

(Bass Level)

TRE

(Treble)

BAL (Balance) or

Fade.

When the desired function is on the screen use the

volume knob to adjust values. Display will return to Volume mode after 3
seconds.

Bass

and

Treble:

“C - 0”indicates center, -2 to –12 is Bass cut +2 to +12 is

increased level.

Balance

: “C 0” indicates center, L1 to L15 indicates left bias. R1 to R15

indicates right bias.

Fade:

“C 0” indicates center, F1 to F15 indicates front bias. R1 to R15 indi-

cates rear bias.

Setting The Clock:

Hold the

SET

button (16) for 2 seconds until the first digit of the time

flashes. Use the

TUNE/SEEK-UP

button (15) or

TUNE/SEEK Down

(14) to set

the Hour.

Press the

SET

button to toggle the display between Clock and Radio

Modes.

Opening and Closing the front panel:

Place thumb on the front panel latch button (20 ) Firmly depress the button
while pulling the front panel open. Keep door firmly closed except when
changing discs.

Radio Operation:

Press the

SOURCE

button (3)to select the Radio Mode. Pressing the Band

Button (19) will toggle through the available radio modes: FM1, FM2, FM3,
AM1, AM2. Each band stores up to 6 independent presets, for a total of
18 FM and 12 AM presets.

Automatically setting the presets:

To automatically set the presets to the next higher stations, press the
preset button (6-11) from which to start programming. Hold the AUTO
button (13) for at least 2 seconds. The current preset and additional pre-
set memories up to P6 will be programmed with the next tunable stations.

To select only the strongest stations, be sure the unit is set to LOCAL
mode (17).

All 18 FM and 12 AM presets can be set sequentially by selecting the next
band and continuing the operation during auto programming.