beautypg.com

Crown Audio CSL 1400 User Manual

Page 13

background image

1400 CSL Power Amplifier

Page 14

Reference Manual

ohms, unbalanced.

Output Connector:

Two sets of color-coded 5-way bind-

ing posts (for banana plugs, spade lugs or bare wire).

Output Impedance:

Less than 10 milliohms in series

with less than 2 microhenries.

DC Output Offset:

Less than 10 millivolts.

Output Signal

Stereo:

Unbalanced, two-channel.

Bridge-Mono:

Balanced, single-channel. Channel 1

controls are active; Channel 2 should not be used.

Parallel-Mono:

Unbalanced, single-channel. Channel

1 controls are active; Channel 2 should not be used.

Protection

The

1400 CSL amplifier is protected against shorted,

open or mismatched loads; overloaded power sup-
plies; excessive temperature, chain destruction phe-
nomena, input overload damage and high-frequency
blowups. It also protects loudspeakers from input and
output DC, as well as providing protection from turn-
on/turn-off transients.

If operating conditions are unreasonable, the patented
ODEP circuitry proportionally limits the drive level to
protect output transistors, particularly in the case of el-

evated temperature. A thermal switch imbedded in the
transformer protects the power supplies from overload.
In the rare event that a transformer overheats, the ther-
mal switch removes power, waits until the unit has
cooled to a safe temperature and resets itself. Con-
trolled slew rate voltage amplifiers protect the unit from
RF burnouts, and current-limiting resistance protects
the input circuitry from overload. (Refer to Section 3.3.)

Turn On:

No dangerous transients. The four second

(approximate) turn-on delay can be changed. Contact
Crown’s Technical Support Group for details.

Construction

Durable black finish on steel chassis with special “flow-
through” ventilation from front to side panels.

Cooling:

Internal heat sinks with forced air cooling for

rapid, uniform heat dissipation.

Dimensions:

Standard 19-inch (48.3-cm) rack mount

width (EIA RS-310-B), 3.5-inch (8.9-cm) height and 16-
inch (40.6-cm) depth behind the mounting surface.

Approximate Weight:

Center of gravity is 6 inches

(15.2 cm) behind front mounting surface.

120 VAC, 60 Hz Units:

36 pounds, 2 ounces (16.4 kg)

net; 40 pounds (18.2 kg) shipping weight.

International Units:

37 pounds, 3 ounces (16.9 kg)

net; 40 pounds, 15 ounces (18.6 kg) shipping weight.