4 specifications – Crown Audio P.I.P.-EDCb User Manual
Page 12
4 Specifications
Note: All specifications are refer-
enced to a 0.775 volt input sig-
nal.
Signal to Noise:
Greater than 95
dB from subsonic filter corner
frequency to 20 kHz.
Frequency Response:
±0.1 dB
from 70 Hz to 30 kHz with sub-
sonic filter corner frequency set
to 36 Hz. +0, –3 dB from sub-
sonic filter corner frequency to
30 kHz.
Harmonic Distortion (THD):
Less than 0.01% THD at 1 kHz.
Common Mode Rejection:
Greater than 65 dB at 1 kHz.
Crosstalk:
Less than 0.5 mV at
20 kHz.
Connectors:
3-pin female XLR
for each input.
Input Impedance:
Nominally 30
K ohms balanced. 15 K ohms
unbalanced.
Maximum Input Level:
35 VAC.
Maximum Output Level:
+18
dB with 600 ohm load.
Nominal Gain:
Unity ±0.5 dB.
Dimensions:
6
3
/
8
x 1
7
/
8
x 3
7
/
8
in.
(16.2 x 4.8 x 9.8 cm).
For Technical Support contact:
Crown Audio Division Technical Support Group
Plant 2 SW, 1718 W. Mishawaka Rd., Elkhart, Indiana 46517 U.S.A.
Phone:
800-342-6939
(North America, Puerto Rico and Virgin Islands) or 219-294-8200
Fax: 219-294-8301 Fax Back (North America only): 800-294-4094 or 219-293-9200
Fax Back (International): 219-294-8100
Internet: http://www.crownaudio.com