Crown Audio P.I.P.-XOV - Manual (Page 11)

Page 12
P.I.P.-XOV
Connectors
Input: Balanced female 3-pin XLR
and balanced 1/4-inch phone jack.
Output: Balanced male 3-pin XLR
and balanced 1/4-inch phone jack.
(The input signal can be switched
to the output connector for external
“daisy chaining.”)
Power Requirements: When plugged
into a
Macro-Tech ® or Com-Tech ®
amplifier, the PIP receives +/– 24 V
power.
Dimensions: 6 3/8 x 1 7/8 x 3 7/8 in.
16.2 x 4.8 x 9.8 cm.
Weight: 8.5 ounces (241 grams).
Note: All specifications referenced
to a 0.775 V input signal.
4 Specifications
Signal to Noise: Better than –85
dB with 800 Hz low-pass or high-
pass (equivalent input noise, 20
Hz to 20 kHz).
Input Impedance: Nominally 20 K
ohms balanced and 10 K ohms un-
balanced.
Output: 10 VRMS balanced maxi-
mum.
Nominal Gain: 1.
Frequency Response: +/– 0.75 dB,
dropping to –3 dB at the selected
crossover frequency (Butterworth
response). See Figures 4.1 to 4.4.
Filters: One low-pass and one high-
pass with user-selectable filter type.
Factory-set for 3-pole Butterworth at
18 dB/octave with 800 Hz crossover
frequency. Bessel or Chebyshev
filters are also available.