Factory Direct Hardware Hansgrohe 10458 Axor Starck - Manual (Page 4)

4
Seal the floor around the plaster shield with waterproof
sealant (1). Gently guide the escutcheon to the floor (2).
Insert the black rubber washer in one end of the hose,
and screw it to the hose outlet on the tub filler. Insert the
screen washer in the other end of the hose and screw
it to the handshower. Place the handshower in the
handshower holder.
User Instructions
Turn the left handle to obtain hot water, the right handle
to obtain cold water.
Pull the diverter to divert the water to the handshower.
When the water is turned off, the diverter will reset to the
tub filler position.
The Starck handshower uses the Rubit TM self-cleaning
system. If limescale deposits are noticed in the spray
channels, they can be easily dislodged. Turn the water
on lightly, and rub across the spray channels with a finger
or a sponge.
If the flow of water from the handshower decreases over
time, remove and clean the screen washer.
A check valve is located in the handshower outlet on the
tub filler to protect against back siphonage. It should be
removed and cleaned yearly.