Factory Direct Hardware Hansgrohe 10071001 - Manual (Page 3)

Install the faucet:
Connect the hoses to the supply stops with 3/8”
compression fittings (not included).
Place the compression nut and ferrule over the shank
of the supply hose. Push the shank into the supply
stop. Tighten the compression nut hand tight, then
finish with a wrench.
Place the faucet and sealing ring on top of the
mounting surface.
From beneath the mounting surface, install the
friction washer, metal washer and mounting nut.
Tighten the mounting nut. Tighten the tensioning
screws.
Install the pull rod (10070001, 10205001 only).
Install the drain.
Turn the water on and check all connections for leaks.
sealing ring
friction washer
metal washer
mounting nut
tensioning screws