Factory Direct Hardware Von Duprin 9947EOF - Manual (Page 4)

3/32"
R max.
Stop
9/16"
1-1/8"
3/8"
CL
1/8"
Latch case
5/8"
Remove material
as necessary to
accomodate 5/8"
latch bolt throw
STRIKE
C
1/4"
1"
2 3/4"
L
1 2 3
8 9 10 Install bottom strike or
prepare threshold. Adjust rods and install
center case cover.
Draw horizontal device
center line (C ).
L
RHR shown
(LHR opposite)
C
L
39-3/8”
to bottom of
door
Determine correct backset,
then mark 4 holes for device
center case using template.
98/9947
(non-fire rated device)
single or double door
98/9947-F
(fire rated device)
or 98/9947
double door with
98/9975 (mortise device)
on opposite door
2-3/4”
backset
2-3/16”
backset
Mark
4 holes
Mark
4 holes
CL
Prepare door per prepara-
tion chart on page 3.
Install top strike and
ratchet release.
338 Top strike
See “Frame Preparation” on
page 6 for cut-out and holes
Ratchet release
Strike
Shim
(if needed) Spacer
(use when frame
has no door stop)
385-A bottom strike
Threshold application
Flat threshold
application
See “Adjust Rods” on page 6 for
adjustment procedure
Center case
cover
J
Remove protective
film from pushbar
H
I
See “Frame Preparation”
on page 6 for holes
4 5
See trim instructions
for pull side door
preparation. Line X-
X in trim instructions
is same as device C.
L
CL
CL
CL
If using an outside cylinder,
check NL drive screw and
install tailpiece guide.
Cut tailpiece
if needed
1/2”
Door
surface
4
Tailpiece
Tailpiece
guide
Rotate tailpiece
guide to match
tailpiece
When installing trim that has a
functional lever, knob, or thumb
piece AND an outside cylinder
to lock and unlock the trim,
remove NL drive screw from
back of device.
DO NOT remove NL drive
screw for the following trims:
NL, EO, DT, TP-2, L-2, and K-2.
With “BE” trim, device may
need rehanded. Look for
instructions on back of trim.
Note: When the NL
drive screw is left in
back of device, the
outside cylinder
will function only
as a Night Latch.
NL drive screw
Rounded
edge
7 Secure device to door as shown,
then hang door on frame.
Device equal
height to bottom
of door on each end
B
C
Mark and prepare
2 mounting holes
and secure screws
(see page3)
Mounting
bracket flush
2” Minimum clearance
(with end cap removed)
If device is too long for
door, see “Cut Device”
on back cover
Center
case
Trim
(optional)
A
See “Screw Chart”
on page 2 for screw
types and sizes
5
Assemble rods and latches and
adjust length for proper door
height.
Follow red and blue instruction cards on
rods to set initial rod length
Fine tune the
overall length
by threading
latch in or
out of rod
Top
length
Bottom
length
9
6
Install rods and latches as
shown.
Top rod
& latch
Bottom rod
& latch
Note: Fire devices use brackets
on both sides of latches
Top rod
Bottom
rod
E
D
G
F
Device aligns with
mounting holes
which were
prepared in step 3.