Factory Direct Hardware Von Duprin 9947EOF - Manual

VON DUPRIN
®
Installation Instructions
Devices covered by these instructions:
98/9947 Concealed Vertical Rod Exit Device
98/9947-F (Fire) Concealed Vertical Rod Exit Device
CD98/9947 (Cylinder Dogging) Concealed Vertical Rod Exit Device
EL98/9948-F (Electric Latch Retraction) Concealed Vertical Rod Exit Device
This product is covered by the
following patent numbers:
3,767,238 4,427,223
3,854,763 4,466,643
4,167,280 4,741,563
®
98/9947
Concealed Vertical Rod Exit Device
Metal Door
Applications
Special tools needed:
5/64” hex wrench
#10-24 tap
Drill bits: #25, 1/8”, 1/4”,
5/16”, 13/32”
8
911376-00
Index:
• Screw chart ................................... 2
• Door preparation chart .............. 3
• Device installation .................... 4-5
• Adjust rods .................................... 6
• Frame preparation chart ............ 6
• Optional equipment ................ 7-8
• Cut device ..................................... 8
2” Minimum clearance
(with endcap removed)
Device aligned
with mounting
holes
2
Tape and mark area being cut.
3
Cut device square. 4
Slide anti-rattle clip into device.
1
Measure amount to cut off device.
Anti-rattle
clip inside
2”
min.
OPTIONAL EQUIPMENT - CONTINUED
1. Remove mortise cylinder cam and reinstall in reverse (Figure 6).
2. Insert key and rotate cam to install the cylinder to the cover plate
(Figure 7).
3. Remove key to slide cover plate in position in the mechanism case.
Std. mortise
cylinder
Mortise
cylinder
cam
Std. mortise
cylinder
Mortise
cylinder
cam
CD function conversion
Figure 6
Figure 7
Std. mortise
cylinder
Cylinder
collar Dogging
plate cover
Offset toward
pushbar
Cylinder
locating washer
Cylinder
lock nut
Mechanism
case
Turn cylinder key clockwise approx. 1/
8 turn for standard dogging
Dogging procedure
Depress pushbar
CD (CYLINDER DOGGING)
CUT DEVICE
If 5/8” diameter wire access hole
has been predrilled in door, cut
device 5/16” from center of hole.
Note
5/16”
Tape
Cover plate
(flush to pushbar)
Pushbar
Remove anti-rattle clip
Cut device square
and remove all
burrs
NOTE: Device must
be cut square for
proper end cap fit
Please give these instructions to building owner after device is installed
911376-00(4) © 2006 Ingersoll-Rand Company Limited