Dexter Laundry T-1200 (30-Cycle) User Manual

Page 2

Please read this information and retain for reference.

WARNING

- THIS WASHER IS EQUIPPED WITH DEVICES AND FEATURES RELATING TO ITS

SAFE OPERATION. TO AVOID INJURY OR ELECTRICAL SHOCK, DO NOT PERFORM

ANY SERVICING UNLESS QUALIFIED TO DO SO.

IT IS THE RESPONSIBILITY OF THE OWNER TO CHECK THIS EQUIPMENT ON A

FREQUENT BASIS TO ASSURE ITS SAFE OPERATION.

A machine should not be allowed to operate if any of the following occur:

• Excessively high water level.

• If machine is not connected to a properly grounded circuit.

• If the door does not remain securely locked during the entire cycle.

• Vibration or shaking from an inadequate mounting or foundation.

WARNING - FOR SAFETY

1. Always shut off power and water supply and wait a minimum of one minute

before servicing.

2. Do not overload the washer.

3. Do not bypass any safety devices of this washer.

4. Do not use volatile or flammable substances in or near this washer.

5. Do not attempt to open door when cylinder is in motion, or when it contains

water.

6. Keep all panels in place. They protect against shock and injury, and add

rigidity to the washer.

MAINTENANCE HINTS

DAILY

• Clean the top and the cabinet to remove residue.

• Clean the soap dispenser and lid.

• Check the drain valve for leaking, and that it opens properly.

• Check the loading door for leaks. Clean the door seal of all foreign matter.

• Leave the loading door open to aerate the washer when not in use.

QUARTERLY

Always shut off power and water supply and wait a minimum of one minute

before servicing.

• Check the V-belts for wear and proper tension.

• Clean lint and other foreign matter from around motor.

• Check all water connections for leaks.

• Wipe and clean the inside of the washer and check that all electrical

components are free of moisture and dust.

• Remove and clean water inlet hose filters. Replace if necessary.

• Check anchor bolts - tighten if necessary

IMPORTANT:

Replace any and all panels that were removed to perform daily

and/or quarterly maintenance.