Dexter Laundry T-1200 (30-Cycle) User Manual

Page 10

OPERATING INSTRUCTIONS

Ensure that power is turned on to the washer.

Ensure that the ADVANCE/RUN/PROGRAM key lock is in the RUN position.

Load the clothes loosely in the cylinder, and latch the door securely.

Be sure clothing does not get caught between the door gasket and tub

front when closing the door.

NOTE: To begin closing the door, the handle must be in the horizontal

position. After moving the door to the closed position, the handle

must be turned down to the vertical position, in order to latch the

door for machine operation.

Select one of thirty cycles by using the SCROLL UP/SCROLL DOWN buttons to

change the number indicated in the two digit LED display. The selection

is made when the number indicated corresponds with the desired cycle.

If you are manually adding wash compounds, add low sudsing powdered

detergent, in the amount shown below, into the detergent compartment on

top of the machine. Location is illustrated on the black cover on the

top of the machine. This compartment will be flushed during the WASH

segment of the cycle. Rinse conditioners may be added to their own

compartment, if desired. This compartment will be flushed during the

FINAL RINSE segment of the cycle.

POWERED

DETERGENT REQUIREMENT

T1200

1/2 CUP

Figure 8 - Recommended Detergent Quantity

If you wish to manually add bleach during the cycle, add bleach in the

round opening in the top of the machine. Location is illustrated on the

black cover on the top of the machine.

NOTE: Any additional washing compounds may be added at the appropriate

time by pouring into the round opening in the top.

7. Push the green START button to start the cycle.

The cycle time remaining is displayed throughout the cycle. The cycle

number in operation can be displayed by pushing and holding START, then

push SCROLL UP. The cycle number will be displayed as long as these two

buttons are depressed. The actual bath temperature can be displayed by

simultaneously pushing the start

and scroll down button.

Soak - At any time during the cycle, the red STOP button can be depressed

to stop the washer. All washer cycle information is retained, and the

door remains locked. The washer will soak the load for 15 minutes, then

agitate for 30 seconds. This will repeat until the cycle is started

again. This feature allows for an extended soak if required. The washer

cycle will continue when the START button is depressed.

The selected cycle can be cleared at any time by depressing and holding

the STOP button for a minimum of three seconds.