beautypg.com

Changing program data – Dexter Laundry T-80 (Commercial) User Manual

Page 9

background image

PROGRAMMING:

(Instructions on Page 10 and 11)

All operating parameters (vend price, temperatures, cool-down times, etc.) are adjustable. In addition, several
displays of information are available from the controller (Money audits, hours run, dryer temperature).

The dryer is ready to run, from the factory, with the following pre-programmed data:

Temperature, HOT or HIGH:

175 (degrees F) / 78 (degrees C)

Temperature, MEDIUM:

150 (degrees F) / 63 (degrees C)

Temperature, WARM or LOW:

125 (degrees F) / 48 (degrees C)

Vend Price:

25 (cents)

Time for Left Coin:

3:20 (3 minutes, 20 seconds for a dime)

(doesn’t apply to single-coin models)

Time for Right Coin:

8:00 (8 minutes for a quarter)

Time of Free Vend:

8:00 (“Free Dry” cycle is 8 minutes)

Cool-down Time, HOT or HIGH:

2:00 (Cool-down time in HOT or HIGH is 2 minutes)

Cool-down Time, MEDIUM:

2:00 (Same as above, except MEDIUM)

Cool-down Time, WARM or LOW: 2:00 (Same as above, except WARM or LOW)
Temperature Scale

F degrees

Decimal Point Display

ON

Seconds on Display

OFF

All of the above data can be easily changed by the owner. The changes are made by the 4 keys or buttons on the
front of the control panel.

CHANGING PROGRAM DATA

Put dryer in PROGRAM mode as instructed on page 10. The dryer remains in the PROGRAM mode until one of
these actions occur:

• The switch is actuated again.
• The seventeenth step is completed and the START switch is pushed following the seventeenth step.
• Programming is stopped for about a minute.
• The loading door is closed.

Observe the displayed value in each step. If no change is required, press START to advance to the next program
step. If a change is required the values are made larger by the HOT or HIGH button, smaller by the MED button. The
hour meter and money audit can be reset to zero if WARM or LOW is pressed.

Note that after any reset or program change it is necessary to advance to the next step by pressing START to enter
the revision. OTHERWISE THE VALUE WILL REMAIN AS IT WAS BEFORE THE ALTERATION.














9