Dexter Laundry T-80 (Commercial) - Manual (Page 10)

PROGRAMMING INSTRUCTIONS:
(To switch to program mode.)
1. Unlock and open the upper service door.
2. Open the loading door.
3. Push the Program Button found just to the left of the
WARM or LOW cycle light. The Button is accessible
through a hole in control mounting plate, after removal
of bright metal plug.
4. The control switches to PROGRAM mode. In PRO-
GRAM mode, the membrane switch keypad becomes
a 4-switch programming tool.
5. The ACTUAL NUMERICAL VALUES desired are keyed
in as explained on P.11.
IMPORTANT: Please remember to push
START
to actually enter (store in memory) new data. If you merely change
the display, memory hasn’t yet been changed -- only
START
will actually change the memory!
10
HOT OR HIGH
MED
OR LOW