Dexter Laundry T-1450 EXPRESS (30-Cycle) - Manual (Page 12)

12
FIGURE 9 - BATH SETTING LIMITS
Settings for
each bath Setting Limits Description
Cycle Time 0 to 30 minutes
(1 min. increments) The Cycle time (tumble) settings are 0 min. to 30 min. in 1 min. increments for each bath. If
the setting is 0, then that bath is skipped over. For the Final Rinse /Extract bath, the
minimum time must be 1 min.
Water
Temp. HOT, WARM,
COLD and NO
WATER The water temperature setting is displayed as HH = hot, CH = warm, CC = cold and EE = No
water bath. When the No Water bath is selected, the water level can be set to either high or low
and NO Injection will be made even if the injection source is programmed.
Water
Level HIGH or LOW The water level setting is displayed as HI for High level and LO for low level.
Injection
Source 0 to 6 The injection source settings are 0 through 6 with 0 being no injection and settings 1 through 6
relating to an injection source. See Recommended Injection Table.
Spin Time 0 to 10 minutes
(1 min. increments) The spin time settings are 0 min. to 10 min. in 1 min. increments. If the setting is 0, there
is no spin for the bath. Final Rinse/Extract minimum setting is 1 min.
PROGRAMMING INSTRUCTIONS - EDITING EXISTING CYCLE
There are 29 preset wash cycles programmed into the washer at the factory.
Although these cycles are common industry cycles, there may be a need to tailor
the cycle to meet an exact application. This can easily be done with the
following instructions. Note: It is recommended when changes are made to one
or more of the preset programs, that the cycle number and the changes be
documented for later reference. Blank cycle sheets have been provided at the
end of the Preset Cycle Information section.
1. Turn on the power to the washer.
2. Turn the Advance/Run/Program key to the Program position, (Program Mode
LED lights).
3. The Select Cycle LED is lit. Select the cycle to be edited by using the
SCROLL UP/SCROLL DOWN buttons. The selection is made when the number
displayed corresponds with the desired cycle.
4. Push the green ENTER button.
Once depressed, the first of the nine cycle segment LED's will light (top
row). The cycle segments are: Flush, Pre-wash, Wash, Rinse 1, Rinse 2,
Rinse 3, Rinse 4, Rinse 5 and Final Rinse/Extract. The Select Cycle LED
is out.
5. Use the Scroll Up/Scroll Down buttons to light the cycle segment to be
changed.
The sequence of steps below are repeated for each cycle segment, until all