Dexter Laundry T-30X2 EXPRESS - 50 Hz Gas (On-Premise) - Manual (Page 4)

4
INSTALLATION AND OPERATING INSTRUCTIONS
Note: Before installation, check that the local distribution conditions, nature of gas and
pressure, and the adjustment of the appliance are compatible.
UNCRATING AND PLACING DRYER
Tools Required: 3/4" (19 mm) hex socket & ratchet driver, wood block 4" (100 mm) or 5" (125
mm) thick, a knife and a groove joint pliers, which will open to 1 3/8" (35 mm).
1. Remove and discard the packaging.
2. The crate base is attached to the dryer by (4) cap screws driven upward from below the crate
base. Remove the crate base from the dryer, by tipping the dryer sidewise and place the block
under the crate base rail in the center of the dryer. Using a ratchet and a 3/4" (19 mm) hex
socket, remove and discard the (2) crating bolts from the side, which is raised. Remove the
block from under the crate base. Repeat for the other side.
3. Install leveling legs. Using a walking motion, move dryer sideways about 6" (150 mm) off of
the crate base. Tip the dryer up and place the block under the edge of the dryer. Thread two
leveling legs about two-thirds into the T-nuts on the base from which the crating bolts were
removed. Remove the block from under the dryer.
With a walking motion, move the dryer completely off the crate base. Discard the crate base.
Tip the dryer sidewise, as previously done, and place the block under the edge of the dryer on the
raised side. Thread the leveling legs into the nuts as was done for the first side.
Slide the unit into the position where it will be installed. Adjust the leveling legs, using the
groove joint pliers, to level and align the dryer with adjacent units.
DRYER INSTALLATION
1. CODE CONFORMITY: All commercial dryer installations must conform to the local and
national codes for the location of installation and ventilation requirements.
2. INSTALLATION CLEARANCES: This unit may be installed at the following alcove
clearances.
I Left side 0 in.
II Right side 0 in.
III Back
18 in. (450 mm) clearance is necessary behind the belt guard to allow for
servicing and maintenance.
IV Front 48 in. (1200 mm) to allow use of dryer.
V Top Refer to figure labeled “Vertical Clearance Dimensions”.
AB. 0 in. clearance at the top, 4 in. (100 mm) back from the front.