Dexter Laundry T-900 (Commercial) User Manual

Page 9

WATER TEMPERATURE PRICING

The washer can be set for different levels of pricing for Cold, Warm and Hot water. The Cold water
setting is considered as the base price, which is the normal washer cycle price.

Stage 4: Warm Water Price – The next step in the pricing program is to set the additional price for
Warm water usage. The additional price is the amount added to the price of a cold wash. The
display will blink first “CH P” indicating cold/hot water mix price and then “00.00”. To change the
value, use the Hot temperature button to decrease and the Warm temperature button to increase. The
value will change in 1¢ steps. The range of values is from $00.00 to $99.99.

When the desired price is displayed, push the Start button once to store the new value and a second
time to move to the next Coin/Price programming step. To exit the Coin/Price programming mode,
push the Cold temperature button for 5 seconds.

Stage 5: Hot Water Price – The next step in the pricing program is to set the additional price for Hot
water usage. The additional price is the amount added to the price of a cold wash. The display will
blink first “H P” indicating hot water price and then “00.00”. To change the value, use the Hot
temperature button to decrease and the Warm temperature button to increase. The value will change
in 1¢ steps. The range of values is from $00.00 to $99.99.

When the desired price is displayed, push the Start button once to store the new value and a second
time to move to the next Coin/Price programming step. To exit the Coin/Price programming mode,
push the Cold temperature button for 5 seconds. The Coin/Price programming mode will
automatically exit and return to the Idle mode if no buttons are pushed for one minute.

Stage 6: Plus Cycle Price -- The next step in the programming sequence is the Plus Cycle feature.
The Plus Cycle adds three (3) minutes of wash time to the wash bath only. The controller can be
programmed to charge a fee for this or the feature can be turned off. The default setting is off. To
turn the Plus Cycle feature off, set the Plus Cycle price to zero.

The display will blink first a “PC P” indicating Plus Cycle price and then price (back and forth). To
change the value, use the Hot temperature button to decrease and the Warm temperature button to
increase. The value will change in 1¢ steps. The range of values is from $00.00 to $99.99. When
the desired price is displayed, push the Start temperature button once to store the new value and a
second time to move to the next Coin/Price programming step. To exit the Coin/Price programming
mode, push the Cold temperature button for 5 seconds.

Stage 7: Decimal Point -- The next step in the programming sequence is the decimal point display.
The display will start blinking back and forth first “dP “ (Decimal Point) and then either “on”
(default) or “off”. Press the Hot or Warm temperature buttons to select the decimal point display as
“on” or “off”. When the desired setting is displayed, push the Start button to store it and a second
time to move to the next programming step.

Note: To not use this feature, set the price to “00.00”.