Dexter Laundry T-900 (Commercial) - Manual (Page 13)

RAPID ADVANCE MODE
To enter the Rapid Advance mode, push and hold the Cold water temperature button and then push
the programming button on the controller. There will be no observed change to the washer or the
display. The Rapid Advance mode can be entered from either the Idle mode or during the cycle. To
rapid advance to the next step in the wash cycle, push the Start and Warm temperature buttons at the
same time. The display will show an “Ad” (advance) in the display. The washer will advance to the
next bath segment. The water will drain before the advance will occur.
The Rapid Advance mode will not end until the final bath segment is completed. The final segment
cannot be skipped in Rapid Advance mode.
Notes: 1. When the Rapid Advance mode is used, the cycle time will no longer be correct.
2. By skipping steps with rapid advance, the door may not open immediately at the end of
the cycle.
EASY CARD
If your Dexter washer is installed with Dexter’s Easy Card debit card system, the card reader signals
the washer control when money is debited from the user’s card account to satisfy the price of the
wash cycle. The washer’s pricing and the Easy Card system pricing are completely independent of
each other and must be programmed separately and coordinated. Refer to the instructions that came
with the Easy Card system for complete information.