Swanstone CS-1616 - Installation - Manual (Page 5)

particles from going into the air. Always work in a well-
ventilated area. Always use an OSHA approved dust
mask when cutting, drilling, or sanding Swanstone
products.
Power Tool Hazard
To prevent personal injury or possible
death, always follow the electrical safety
recommendations of the power tool’s
manufacturer. Do not use power tools in an unsafe
manner. Power tools should only be connected to a circuit
protected by a ground-fault circuit interrupter (GFI).
Shock Hazard
Never use electric power tools around
water, condensation, or other liquids.
Electric shock can cause severe
burns, significant injuries, and even death. If an
extension cord is required, always use an OSHA
approved extension cord. Power cords should only be
connected to a circuit protected by a ground-fault circuit
interrupter (GFI).
Electrical Shock Hazard
Contacting l
ive electrical wiring with
power tools or hand tools can cause
serious injury or death. Make sure all
related circuit breakers are turned OFF. Test for live circuits
or wiring inside any wall where installation of the
Swanstone product requires cutting into a wall.
Electrocution Hazard
Water and other liquids conduct electric
current and can create a short circuit,
resulting in injury or death. Keep all
liquids away from electrical cords and power tools. DO
NOT create a short circuit between a source of electricity
and a liquid by being in contact with both simultaneously.
General Information
Required Tools
Tape measure
Level and pencil
Drill with 3/16” and 3/8” drill bits
1/2” socket or wrench
Caulking gun
60 grit sandpaper
Clean paper towels or shop towels
Denatured alcohol
Kit Contents
Confirm that all parts of this kit have been included
before beginning installation.
One solid surface Swanstone corner shower seat
One stainless steel mounting bracket
Six 5/16” x 2 “ hex head lag bolts
Six 5/16” flat washers
One tube of silicone adhesive
Helpful Hints
Read these instructions carefully and familiarize
yourself with the various parts of the kit.
We recommend you allow sufficient time for the parts
in this kit to adjust to room temperature before
beginning installation.
Store unused materials away from the work area to
prevent accidental damage.
800-325-7008 5 The Swan Corporation – Swanstone
Safety Guidelines General Information