Swanstone WB-2218 - Installation - Manual (Page 8)

2. Clean underside of vanity sink with denatured alcohol.
Remove all dust and allow the surface dry completely.
S So ollv ve en ntts s H Ha az za arrd d
Follow all manufacturers’
safety instructions for silicone
sealants and denatured alcohol. Alcohol vapors are both
flammable and hazardous to breathe. Silicone vapors may
irritate eyes and nose. Personal injury can result from
improperly handling or use of products, such as denatured
alcohol. Always follow the manufacturer’s
recommendations for the safe use of these products.
Ventilate any work area before beginning to apply silicone
sealants, cleaning agents, or solvents.
3. Apply a bead of adhesive or silicone onto each corner of
cabinet top.
4. Place Swanstone vanity top onto the cabinet, making sure
vanity is seated properly.
5. Wipe off any excess adhesive, and allow vanity top to set
for 24 hours to ensure maximum adhesion.
6. If desired, use a color-match silicone sealant (not
included). Place a bead of sealant along the seam of the
back splash panel and wall to create a moisture barrier.
7. Apply sealant to the bottom side of the sink ring
Note: When installing the sink ring and tail pipe, use
plumber’s putty sparingly and do not allow it to contact
the plastic overflow assembly under the sink.
Apply Plumber’s
Putty
Here
VI-050
VI-013
VI-006
VI-004
WARNING
VI-007
Denatured
Alcohol
The Swan Corporation – Swanstone 8 800-325-7008
Installation Procedure