Swanstone ST-1W - Installation - Manual

Installation Procedure for
ST-1F/BC-4400 FIBERGLASS LAUNDRY TUB
Installation Procedure for
ST-1F/BC-4400 FIBERGLASS LAUNDRY TUB
1. After securing all plumbing . . . attach the complete drain fixture
in sequence shown. Note that it is necessary to apply silicon or
latex caulking to the flange before tightening down in position.
After assembly, tighten entire unit and check for leaks.
2. Leg mounted laundry tub - each of the four legs is provided
with a combination metal/plastic adjustable glide.
Step 1. Place the end of the glide plug into the round end of
each leg, grasp leg firmly and with a downward thrust bang
the entire unit on a hard surface until the glide plug has been
completely seated. Step 2. Screw the adjustable glide into the threaded holes of
the plug.
3. Installing legs - with your laundry tub upside down . . . locate
the crimped end of each chrome leg . . . align the crimped end
with the tapered beading inside each molded leg hole of the
laundry tub. Insert leg, being sure that the crimp matches the
position of the beading, and then push inward until completely
seated. It may be necessary to twist each leg slightly to achieve
a firm seating. Set laundry tub upright, adjust glides when in
place.
FORM #519-12-11-2M
1. Wall mount laundry tub - place laundry tub on flat surface,
bottom up. Locate left and right filler brackets over guide post
and screw hole. Be sure the slot at the end of each panel is fit-
ted over provided beading for locking panel in position. Once
in place, insert screws provided into screw holes and do not
over tighten.
2. & 3. Hanging bracket for wood stud wall - locate your studs .
. . mark wall for comfortable working height and position hang-
ing bracket 1” below. Be sure you mark holes to be drilled over
studs. Use a bubble level to assure levelness of bracket. When
drilling holes, be sure to use a drill bit slightly smaller than the
size of the screws. (Included) See drawings and detail. 4. Hanging bracket on concrete or cement wall - position the
hanging bracket in the same manner as above, but note that
attaching to concrete or cement walls requires an anchor fitting
for the screw. Use a bit designed for this surface and drill a
hole slightly smaller than the provided anchor. Then attach the
bracket with the lag screw and draw them up firmly, but not too
tight. See drawings and detail.
After securing all plumbing . . . attach the complete drain fixture
in sequence shown. See drawings and detail on back.
Strainer Body
Washer
Flange Nut
Washer
Tail Piece Nut
Stopper
Apply silicon or
latex caulking
under flange of
strainer
In the installation of the ST-1, DO NOT use the white washer in the
installation process. Use of the white washer may cause the drain
to seat improperly and cause water to pool around the drain area.
Swan
C O R P O R A T I O N
Swan
C O R P O R A T I O N