beautypg.com

General information – Swanstone SB-1248 - Installation User Manual

Page 6

background image

Required Tools

 Circular saw with 60 to 80 tooth carbide blade
 Tape measure
 Masking tape (2” wide works best)
 Caulking gun
 Clean paper towels or shop towels

Kit Contents

Confirm that all parts of this kit have been included
before beginning installation.

SB-1248 Bench Seat Kit

(51-5/16 long x 14 wide x 1-9/16” thick; 16.5 lbs.)

1 — Seat Panel (12-3/4” x 48” x 0.400”)

SS-29 Installation Kit

(13-3/4 long x 13-3/4 wide x 3-1/8” thick; 7 lbs.)

4 — Cartridges of clear silicone sealant for back and

side panels

1 — Tube of color matched 100% silicone sealant for

corners, corner moldings, and recessed shelf

1 — Tube of white silicone sealant for caulking around

the outer perimeter of shower

Unpackaging

 Use care when opening the box so that you do not

damage the panel.

 This product is shipped to you or your retail center

after careful inspection. After purchasing the kit,
carefully unbox and inspect the product for any
shipping damage that may have occurred. If damage
is found, report it immediately to the store of
purchase. After inspection and during installation,
protect the products from construction damage, by
moving them to another room or area until ready to
install.

 Store the panel in a flat area to avoid warpage until

the time of installation. Do not store the panel
outside of the original packaging in a vertical position.

 Please use the model number located on the side of

the box or the front of this manual when contacting us
with questions concerning the installation of this unit.

Helpful Hints

 Read these instructions carefully and familiarize

yourself with the various parts of the kit.

 The variety of installations possible for this kit may

require procedures other than those shown. Ensure
construction is correctly sized, plumb, and square.

 Allow sufficient time for the parts in this kit to adjust to

room temperature. We do not recommend
installation of this product at temperatures below 65
degrees.

 Saw horses with 2 x 4 cross-members or a worktable

is helpful during the installation process.

 Always transport the panels vertically. Use care

when laying the panels flat to prevent flexing,
especially when panels have a cutout in them.

 Store unused materials away from the work area to

prevent accidental damage.

Preparation Tips

 Turn off the hot and cold water supply.
 Ensure all plumbing or electrical work inside the walls

is finished prior to installation of the bench seat.

 Prepare the area with 1/2” (13 mm) moisture-resistant

drywall, marine grade plywood, or concrete board.
Never install our products directly on any surface that
is, or may become, wet or damp.

 Trial fit the panel before you begin. Swanstone

panels have a finished side and a nonfinished backer
side. The Swanstone panel has a sticker or stickers
attached to the nonfinished backer side and, upon
installation, should be placed against the mounting
surface.

 The mounting surface must be free of dirt, film,

waxes, or any other residues.

Caulking Tips

 Follow the instructions on the caulking tube.
 When job is complete, inspect all caulked areas for

gaps and fill as needed.

 Clean up any excess silicone that was missed using

denatured alcohol and a clean cloth.

 Be very careful not to disturb caulk joints.

The Swan Corporation – Swanstone

6

800-325-7008

General Information