Swanstone SS-WTK - Installation - Manual (Page 2)

INSTALLATION PROCEDURE
Remove unnecessary window moldings, if any, and clean area of dirt, chipped paint, loose plaster, etc.
TOOLS REQUIRED TO INSTALL
The only tools needed are a saber saw, ruler, and caulking gun.
DO NOT NAIL PANELS TO WINDOW SILL OR JAMBS.
WINDOW TRIM KIT MODEL SS WTK
A. Taking into account the
installation option you choose,
measure the side of the sill
opening. Then measure the
depth of the sill area, mark
and cut panel to exact size.
NOTE: IT IS ADVISABLE TO
TRIAL FIT ALL THREE PAN-
ELS BEFORE CUTTING.
B. Cut the left and right jamb
panels to the desired height
and depth. Again, consider
the application that you have
chosen; this will determine the
size of your cut. If applicable,
you may wish to line up the
jamb panels with the height of
the tub surround material. C. Apply adhesive per “S”
pattern shown to the under-
side of the sill and press firm-
ly into place. Repeat the same
procedure for the two jamb
panels. Press down on all
panels to insure good contact. D. Caulk all edges to seal out
moisture.
NOTE: ALLOW ADHESIVE
AT LEAST 24 HOURS TO
CURE BEFORE USING.
CLEANING
Clean your Swanstone Window Trim Kit as you would any other fine bath fixture, using normal household detergents and cleansers. Just
wiping the surface quickly removes watermarks and residue. Occasional scrubbing with household abrasive cleansers maintains
Swanstone’s beautiful luster.
REPAIRING
Use 400 grit sandpaper to remove scratches and gouges in the surface. A “Scotchbright” pad can be used to blend the repair into the
surrounding area.
The Swan Corporation
St. Louis, MO 63101
FORM #527-9-98-5M
Depth of jamb
Height of jamb
Notched cut
illustrated:
Your cut may
be different.