Swanstone CCSP-4896-1 - Installation - Manual (Page 14)

2. Place two braces against each left and right wall.
3. Install (wedge) three horizontal braces (six total) against
the left and right wall braces.
4. Insert small blocks between the front-to-rear panel braces
and the back panel braces. These will apply pressure to
the back panel to hold it in place.
5. Remove the braces after 24 hours.
Corner Soap Shelf Installation
The soap shelf is a corner mount design. The soap shelves
can be stacked in one corner or placed in opposite corners.
1. Select a desirable height for mounting one or both soap
shelves. A height of at least 43” from the shower floor to
the soap shelf is recommended.
2. After marking the height, draw a 4” level line on both
walls. These lines will be used to align the top edges of
the soap shelf.
3. Dry fit the soap shelf prior to applying clear silicone. The
soap shelf may require sanding to fit precisely in the
corner. The actual angle of the soap shelf is slightly
greater than 90 degrees to accommodate some
adjustment. If necessary, mark and sand the side(s) of the
soap shelf to achieve a proper fit, using a coarse grit (60
grit) sandpaper.
43"
The Swan Corporation – Swanstone 14 800-325-7008
Installation Procedure