R&M Materials Handling VARIABLE SPEED CONTROLS CMXC 007 Service Manual User Manual
Page 2
R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
2/9
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
Table of contents
1
DESCRIPTION OF THE INVERTER .................................................................................................. 3
1.1
Connections ............................................................................................................................................ 3
1.2
Technical characteristics ......................................................................................................................... 3
1.3
Normal operation .................................................................................................................................... 4
1.4
Status indication leds (green and red) ..................................................................................................... 4
1.5
Compact brake motors ............................................................................................................................ 4
1.6
Programming switches ............................................................................................................................ 4
1.7
The EMC requirements ........................................................................................................................... 5
1.7.1
EMC filter connection to inverter for trolley travelling. ........................................................................... 5
1.7.2
EMC filter connection to inverter for bridge travelling. .......................................................................... 5
2
DESCRIPTION OF CONTROL MODES ............................................................................................. 6
2.1
MS2-control (S4-1=OFF) ......................................................................................................................... 6
2.2
EP2-control (S4-1=ON) ........................................................................................................................... 6
3
FAULT CODES, TROUBLESHOOTING ............................................................................................. 7
4
PROGRAMMING OF THE APPLICATION PARAMETERS ................................................................ 8
4.1
Minimum speed, maximum speed and ramp time .................................................................................... 8
4.1.1
Acceleration and deceleration ramp..................................................................................................... 8
4.2
Selection of the motor type ...................................................................................................................... 9