Prokit's Industries PT-5201A-B - Manual (Page 6)

5
perts
e considerable danger for the user.
3. Store these instructions for future reference.
ssory into the collet.tighten the collet nut.
elease the spindle lock button in order to remove the accessory,
er.
collet nut and the old collet. Place the new collet in.
indle
off before
placing the collet; Choose a low speed at first for working.; Never
ces. A mandrel is used for mounting a polishing wheel.
lace the mandrel in the collet nut Place a polishing wheel on the
ing. A router bit is used for grooving and for routing figures in
astic, wooden and metal workpieces. Place a router bit in the collet
is built accordance with the relevant safety rules. Repair of
electric appliances must only be carried out by ex
otherwise it may caus
2
Assembly and operation
Mounting an accessory
Keep the spindle lock button depressed. Slacken the collect nut.
Insert the shaft of the acce
R
proceed in reverse ord
Replacing the collet
Keep the spindle lock button depressed. Slacken the collet nut.
Remove the
Replace the collet nut and tighten the collet nut. Release the sp
lock button.
CAUTION! Always Unplug from the tool and switch
re
press the locking pin while the machine is running
Polishing. A polishing wheel is set for polishing metal and plastic
workpie
P
screw.
Roug
pl
nut.
Grinding and sanding. A grinding stone in used for grinding metal,
plastic, wooden and the stone workpieces, A sanding band is used
for sanding wooden and plastic workpieces. Place a grinding stone
or sanding band with mandrel in the collet nut. A sanding band must
be replaced when showing signs of wear Remove the old sanding