Prokit's Industries MT-1910 - Manual (Page 7)

10
5-9. Temperature measurement
To measure temperature, please use the Multi-Function Socket.
1. Set the rotary switch to the “TEMP” range, then the “OL” displayed on the
LCD.
2. Insert the Socket to the two “COM” and “TEMP” terminals.
3. Insert the K-type temperature probe to the two insert holes of Socket. User
should take note of it’s polarity.
4. The measured temperature value will be displayed on the LCD.
Note:
The two “Temp” & “COM” pins of Socket must be direct at the two “TEMP”
& “COM” terminal respectively.
6. Maintenance
6-1. Battery replacement
When meter display the battery must be replace to maintain normal
operation.
1. Disconnect and remove all test probes from any live source and meter.
2. Open the battery cover on the bottom case by screwdriver.
3. Remove old battery and snap new one into battery holder
6-2. Fuse replacement
Replacing the defective fuse should the done according to the following
procedure.
Certificate Number: TW98/12323QA
1. Remove the test lead and turn off power.
2. Open the battery cover on the bottom.
PROKIT’S INDUSTRIES CO., LTD
3. Remove the defective fuse and insert a new fuse of the same size and
rating.
http//:www.prokits.com.tw
e-mail: [email protected]
4. Replace the bottom case and reinstall all the screw.
6-3.Cleaning and Decontamination
The meter can be cleaned with soft clean cloth to remove any oil, grease or
grim. Do not use liquid solvent or detergent.
11