Prokit's Industries MT-1610 - Manual (Page 2)

1.1.2 When the meter is delivered, check if it has
been damaged in transit.
1.1.3 When harsh preservation or shipping
conditions caused, inspect and confirm this meter
without delay.
1.1.4 Test leads must be in good condition. Before
using, verify that the insulation on test leads is not
damaged and/or the leads wire is not exposed.
1.1.5 Full compliance with safety standards can be
guaranteed only id used with test leads supplied. If
necessary, they must be replaced with the same
model or the same class.
1.2 DURING USE
1.2.1 Never exceed the protection limit values
indicated in specifications for each range of
measurement.
1.2.2 When the meter is linked to measurement
circuit, do not touch unused terminals.
1.2.3 When the value scale to be measured is
unknown beforehand, set the range selector at the
highest position.
1.2.4 Before rotating the range selector to change
functions, disconnect test leads from the circuit
- 2-
under test.
1.2.5 When carrying out measurements on TV or
switching power circuits, always remember that
there may be high amplitude voltages pulses at
test points which can damage the meter.
1.2.6 Never perform resistance measurements on
live circuits.
1.2.7 Always be careful when working with
voltages above 60V dc or 30V ac rms. Keep
fingers behind the probe barriers while measuring.
1.3 SYMBOLS
Important safety information, refer to the
operating manual.
Conforms to European Union Directive
Earth ground
1.4 MAINTENANCE
1.4.1 Please do not attempt to adjust or repair the
meter by removing the rear case while voltage is
being applied. A technician who fully understands
danger involved should only carry out such
actions.
1.4.2 Before opening the case of the meter, always
- 3-