Prokit's Industries NT-6580 - Manual (Page 6)

5. Measurement
Single Distance Measurement
Figure (D)
Follow the steps below to take single distance
measurement.
(1) Press
to activate the laser, and aim at the
object which is to be measured.
(2) Press again to take measurement. Results will
be seen on display immediately.
Continuous Measurement
Long press button, until you hear beeps, to activate continuous
measurement. Under this mode, minimum or maximum distance can be
measured from a fixed measuring position by sweeping ideal points.
It’s usually used to find the right angle and diagonal. User can press
or to stop continuous measurement and the values of minimum and
maximum distances are shown in the display as well as the last
measured value in the summary line.
Area Measurement
Press once, the symbol appears on display.
Press to take the first distance measurement (e.g. Length).
Press again to take the second distance measurement (e.g. width).
The results of length, width, perimeter, area will be seen on display
orderly.
5