Prokit's Industries SS-611 - Manual (Page 9)

8
condition.
4. Always switch off before you put the heat gun down.
5. Do not let anyone under 18 years operate this tool.
6. Rags, cloths, cord, string and the like should never be left around
the work area.
7. If you are interrupted when operating the tool, complete the
process and switch off before looking up.
8. Do not block the air inlet or outlets.
9. Do not use in proximity to flammable materials.
Maintenance
There are no serviceable parts, no maintenance is required.
Power cord maintenance
If the supply cord needs to replace, the task must be carried out by
the manufacturer, the manufacturer’s agent, or an authorized service
centre in order to a safety hazard.
Cleaning
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly .Cleaning is best done with a rag.
Wear safety goggles or an eye shield and gloves whist cleaning.
3. Never use caustic agents to clean plastic parts.
CAUTION. A mild detergent on a damp cloth is recommended.
Water must never come into contact with the tool.
General inspection
Regularly check that there is no damage to the heat gun.