PowerWalker VI 1000 IEC - Manual (Page 5)

Before battery replacement, please ensure the power switch on the UPS is in “OFF”
position.
Step 1: Remove the front panel of the UPS
Step 2: Unscrew and remove the battery bracket
Step 3: Disconnect the battery cable and pull the battery out onto a flat
area
Step 4: Slide the new battery and reconnect the battery cable by
screwing up the battery retaining battery bracket
Step 5: Close and reinstall the front panel of the UPS
After the UPS has been installed, you must install the software(Smart Power) that
came packaged with your UPS. Smart Power monitoring software performs the
monitoring and controlling functions. This software displays the status and diagnostic
symptoms on the monitor. In case of the power failure, it provides the auto shutdown
for the computer.
If you download the software from Internet, please key the serial number:
726T25-4791-2N39546.
6. MONITORING SOFTWARE 5. BATTERY REPLACEMENT