beautypg.com

Safety, Warning – BabyTrend SS70762 - TAG-A-LONG LT - RED ROCK User Manual

Page 5

background image

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

7

8

SAFETY

SAFETY

safety by sliding buckles in either direction.

Safety straps are to fit snug around your child.

(Fig. 14)

• To release, push Red Button on Center Clasp,

the two Harness Buckles will pop free.

(Fig 15) This process requires a moderate

amount of effort so as to prevent an accidental

release by your child.

TRAVEL SYSTEM - Safety Belt

• Strap the safety belt over the infant car seat

through the seat belt slots on the infant car

seat, connect the buckles together (Fig. 16).

The safety belts for the infant car seat is

located in small pockets on outer sides of seat

pads. Tighten the strap so the infant car seat

fits snug and can't move.

IT IS VERY IMPORTANT THAT THE

INFANT CAR SEAT STRAP IS ALWAYS

TIGHTLY FASTENED AROUND THE

INFANT CAR SEAT.

JUMP SEAT - 3-Point Harness

• Secure the child with the jump seat 3-point

harness (Fig. 17) when child is sitting on the

jump seat.

PLATFORM - Safety Belt

• Secure the stand feature safety belt behind

child and engate buckle (Fig. 18). This is the

same safety belt you use to secure the rear

infant car seat.

TO RECLINE SEAT

FRONT SEAT

The front seat has a two position recline. To

recline the seat, rotate the recline bar and press

backward on the seat back. (Fig. 19) To place the

seat in the upright position, press upward on the

seat back while rotating the recline bar.

WARNING:

The upright

position should be used only for a

child that is at least 6 months old.

WARNING:

Avoid serious

injury from falling, ALWAYS use

the safety belt to secure the car seat.

Attach the infant car seat:

Position the Infant Car Seat facing toward the rear

of the stroller, so that the seat shell goes into the

front tray and latches into place. (Fig. 20)

Check that the Infant Car Seat is firmly locked

onto the front tray before using

.

Check that the infant car seat is firmly locked onto

the child tray then

STRAP THE SAFETY BELT

OVER THE CAR SEAT

through the seat belt

slots on the infant car seat, connect the buckles

together. (Fig. 21) Tighten the strap so the infant

car seat fits snug and can't move.

IT IS VERY IMPORTANT THAT THE INFANT

CAR SEAT STRAP IS ALWAYS TIGHTLY

FASTENED AROUND THE INFANT CAR

SEAT.
DO NOT USE INFANT CAR SEAT

WITHOUT THE SAFETY BELT.

Fig. 16

Fig. 17

Fig. 18

Fig. 19

Fig. 15

Center Clasp

Fig. 20

Locks

into tray

Fig. 21