Assembly safety, Warning, Strangulation hazard – BabyTrend SS70762 - TAG-A-LONG LT - RED ROCK User Manual

Page 4

ASSEMBLY

SAFETY

To remove the child tray:

Press the red snap button and rotate they tray

upward, then release the snap button located on

the underside of the right armrest and pull the tray

until it released. (Fig. 8)

PLATFORM

To attach platform:

Squeeze both locking clips with both hands

while holding the platform vertically (Fig. 9).

Then slowly rotate the platform downward until

it rests in place on the axle rod. Once in place

release both locking clips. (Fig. 10)

CANOPY

To attach the canopy:

Line up the male fittings on the canopy with

the slots on the armrest and push both fittings

downward until snapped into place. (Fig. 11) To

open the canopy, push forward on the front edge

of the canopy while holding the rear of canopy

in place. To fold the canopy, push forward on the

front edge.

To remove the canopy:

Press the snap button under the armrest and pull

to release the fitting from the slot. Repeat for the

other side.

Before placing your children in the stroller,

please follow the instructions below.

WARNING:

Always set

brakes when the stroller is not being

pushed so that the stroller will not

roll away. NEVER leave stroller

unattended on a hill or incline as

the stroller may slide down the hill.

BRAKES

To engage brakes, apply light downward pressure

to the brake lever located on each rear wheel. The

stroller may require slight forward or rearward

movement in order to line up the teeth on the

brake with each wheel brake cluster. (Fig. 12)

Check that the stroller will not move and that both

brakes are properly applied. To release, gently lift

up on the brake lever. (Fig. 13)

TO SECURE THE CHILD

WARNING:

Avoid serious

injury from falling or sliding out.

Always use the safety harness.

STRANGULATION

HAZARD:

Child can

strangle in loose straps. Never leave

child in seat when straps are loose

or undone.

• Carefully place the child in the stroller seat

and bring the safety harness around the child's

waist. Place the crotch strap between your

child’s legs. Insert the Harness Buckles into

the Center Clasp with the Red Button. Adjust

waist straps for your child’s comfort and

Fig. 11

Fig. 14

Adjust for a snug fit

Fig. 9

Fig. 10

Fig. 8

Fig. 12

Fig. 13