Rainbow Electronics FARGO MAESTRO 100 (with TCP_IP) - Manual (Page 10)

Confidential, the whole present document is the sole property of Maestro Wireless
Solution Limited.
9
4. Connect the modem to external device
You can use the optional 'Y' cable to connect the modem's Sub-D connector to
external controller/computer. Note: The modem CANNOT be directly connected to the
'LINE' jack of a landline telephone.
Connection example using optional 'Y' cable:
RS-232 port of PC
Handset of phone
DB-9
connector
4p4c
plug
Sub-D 15 pin
connector
Maestro
100
5. Connect the DC power supply
Connect the open ending of the inducted power cord to a DC supply. Refer to the
following for power supply requirement.
Input voltage range 5V – 32V
Rated current 650 mA
AC-DC Adaptor
or battery
(Not included)
Solder wire
endings
Connect the connector to the modem. The modem will turn on automatically.
The status indicator on the modem will be lit when power on. After a few seconds it will
go flashing slowly (registered to the network successfully refer 1.2.1).